![]() ![]() into the File>Preferences>Additional Boards Manager URLs field of the Arduino IDE. Start Arduino and open the Preferences window.To support esp8266 programming on arduino IDE you need to have the appropriate board library installed.Arduino is using a different GPIO mapping than the most ESP8266 are labeled.Open it with Arduino GUI and edit the lines 7,8 with your WiFi credentials and 9 (if you are using a different GPIO). What you ineed is the "Wifi_HDD_LED_Arduino.ino" file located into "Arduino" folder. Just head to github and download the source code. Using arduino IDE is quite popular nowadays so I wont write a guide for this. Uploading the lua files can be done by using the attached "Selene beta" program or any other uploader program you like. You should customize the WiFi settings on a (by changing the line: (1) station_cfg= station_cfg.ssid=" YourSSID" station_cfg.pwd=" YourPASS" station_cfg.save=true) and then upload the three files to your module. Lua files to program your module can be found on github: Once the flashing is done the three lua files should be uploaded to the ESP8266 module. If you need more info on flashing visit this link. ESP-01, should be put in flash mode before, this can be done by shorting Pin3 (GPIO2) with the ground during power up. I recommend you to use the NodeMCU pyflasher. The seven pre-selected basic modules are enough (file, GPIO, net, node, timer, UART, WiFi).įlashing the firmware to the module is not difficult. The ESP8266 module should be flashed with NodeMCU firmware. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |